Do you service Denso SCARA robots as well as six-axis?

Yes — HSR and legacy HS SCARA units alongside VS and VP six-axis arms, on RC7, RC8, and RC9 controllers.

Can you recalibrate a Denso robot after a belt or motor change?

Yes. We perform CALSET, verify TCP, and run repeatability checks against your process tolerance before returning the cell to production.

Can you recover a Denso controller from a backup?

Yes. We restore projects and parameters from WINCAPS backups and rebuild controller configuration after hardware replacement.

Tier-1 platform expertise

Denso robot repair & maintenance in Indonesia

Denso robots carry Indonesia's precision assembly — compact VS and VP six-axis arms and HSR SCARA units running electronics, automotive component, and pharmaceutical lines on RC7, RC8, and RC9 controllers.

Ojala services these high-cycle machines where precision matters most: calibration you can measure, preventative programs tuned to cycle counts, and rapid response when a line stops.

What we handle on Denso systems

Controller diagnostics & repair

RC7, RC8, and RC9 fault tracing — servo drives, I/O and fieldbus faults, teaching pendant issues, and project recovery from WINCAPS backups.

Precision calibration

CALSET after motor or belt replacement, TCP verification, and repeatability checks against the tolerances your assembly process actually needs.

Mechanical service

Harmonic drive and belt replacement, motor swaps, and bearing service on high-cycle SCARA and compact six-axis arms.

Preventative maintenance

Cycle-count-based service programs: belt tension, grease, battery replacement, backup management, and per-unit condition reports.

Line support

24/7 response for stopped assembly lines, plus integration support when Denso cells are re-tooled for new products.

Why plants choose Ojala for Denso

High-speed assembly leaves no margin for drift. We service Denso arms to measured tolerances, not just error-free status — backed by the same 24/7 SLA and ARIA triage that covers our whole Tier-1 practice.

Frequently asked

Do you service Denso SCARA robots as well as six-axis?: Yes — HSR and legacy HS SCARA units alongside VS and VP six-axis arms, on RC7, RC8, and RC9 controllers.
Can you recalibrate a Denso robot after a belt or motor change?: Yes. We perform CALSET, verify TCP, and run repeatability checks against your process tolerance before returning the cell to production.
Can you recover a Denso controller from a backup?: Yes. We restore projects and parameters from WINCAPS backups and rebuild controller configuration after hardware replacement.

We also service

Start with the production problem

Talk to an engineer about your line.

Consult an engineer — akbar@ojala.id

Jl KH Agus Salim No. 6 · Bekasi Timur · Indonesia

← Back to the Ojala world